For your safety This new appliance is easy to use, however, make sure to read this handbook before installing and using it for the first time. In this way you can obtain best use, avoid incorrect operations, use the appliance in complete safety and respect the environment. ●...
Contents For the installer For the user Technical specifications For your safety Instructions for the installer Operating instructions Electrical connection Cleaning and maintenance Conversion to other types of gas Periodical maintenance Fitting on modular cabinets Assistance and spare parts Instruction guide This appliance complies with the following EEC Directives: The following symbols will help you quickly find the...
The cooktop lid For correct use of the rings (only for tops with enamelled iron grates) To ensure lower gas consumption and better efficiency, only use flat bottom recipients of suitable size for the rings, as In order to obtain an aesthetic alignment with the kitchen given in the table.
Cleaning and maintenance Before carrying out any operation, disconnect the appliance from the power supply and allow it cool General cleaning Clean the enamelled parts with lukewarm water and de- Chromed caps and grates tergent; do not use abrasive products which could dam- age them.
Important! For correct broiler operation, correctly reposition the screen (see fig. 3). Electric broiler Clean the broiler when it is cold, using absorbent paper or a damp cloth that does not leave strands. Carefully dry the broiler before using it again. It is advisable to occasionally go over it with a little cooking oil or paraffin oil, while it is still warm.
Instructions for the installer IMPORTANT: This appliance can only be installed and Connection used in permanently ventilated places. Make the connection to the gas system using a rigid ● Appliance installation and connection to the power metal pipe and fittings complying with the current stan- supply must only be carried out by QUALIFIED dards, or with a s/steel flexible tube complying with the PERSONNEL.
Replacing the power cable The power cable connection to the terminal block is of the “Y” type: the flexible cable can only be replaced with the use of a special tool that the service technicians have. When replacing the power cable only use H05V2V2-F T90 type cables suitable for the load and operating tem- perature.
Conversion to other types of gas Replacing nozzles 1. Remove the grates. 2. Remove the burner caps and flame spreaders. 3. Using a 7 mm socket wrench, unscrew and remove (Fig. 16) the nozzles, replacing them with those required for the type of gas used (refer to table 1 on the previous page).
Fitting on modular cabinets A SR Dimensions in mm A = Auxiliary burner SR = Semirapid burner This top is designed for fitting on modular kitchen R = Rapid burner cabinets having a depth of between 550 and 600 mm and B = Broiler appropriate characteristics.
Fitting possibilities On base cabinet with door Adequate arrangements must be provided for in the con- struction of the cabinet, to prevent possible contact with the overheated housing of the top during operation. A possible solution for avoiding this problem is illustrated in fig.