Advertisement
INSTALLATION INSTRUCTIONS
Built-in appliances
•
Only use the built-in appliances after you assemble
the appliance into correct built-in units and work
surfaces that align to the standards.
To attach the seal
•
Clean the worktop in the area of the cut out section.
•
Bond the seal stripe supplied on the lower edge
of the appliance along the outer edge of the glass
ceramic. Do not extend it. Let stay the cut ends in the
middle of one side. When, you cut it to length (add
some mm), push the two ends together.
Connection cable
•
Use the correct mains cable of type H05BB-F Tmax
90°C (or higher) for a single phase or two
phase connection.
•
Replace the damaged mains cable with a special
cable (type H05BB-F Tmax 90°C or higher). 3 x
2.5mm2 with an all-pole 25A breaker. Speak to your
local Service Centre.
•
The earth cord (green/yellow/cable) must be 2cm
longer than phase and neutral cable (blue and brown
cables).
•
The cable conditions must be in accordance with
regulations and the terminal screws tightened
securely.
•
The connecting cable is to be secured with the mains
cable cleat and the covering closed by pressing firmly
(lock into place).
•
Before switching on for the first time, any protective
foil or stickers must be removed from the glass
ceramic surface.
Assembly
min. 600mm
NOTE: The clearance must meet or exceed the
minimum recommended for both the rangehood and
cooktop. Refer to the rangehood installation manual.
Before the installation, note down the serial
number (Ser. Nr.) from the rating plate. The rating
plate of the appliance is on its lower casing.
Refer to "Safety information" chapter.
min. 50mm
TIPS & INFORMATION
IMPORTANT
WARNING
WARNING
5
Advertisement
