Table of Contents
Advertisement
instructions
7 installation
Installation procedure
• Before installing the appliance, check that the location
provides the required clearances from combustible
materials and check if necessary to provide protection to
adjacent surfaces as required by the regulation. Make
provision for the gas supply to be connected to the
location.
• Cut the opening in the bench top by the cardboard -
template given in the hob packing or to the dimensions
shown in Fig 7.
• Remove the hob from the carton.
• Install the hob in the cut-out (Fig 7)
• Connect gas supply to inlet of hob. Turn the gas on
and check for leaks using soap solution and brush
around all the joints and connection.
• Test the appliance; depress the control knob and turn to
full flame setting to activate the electric igniter. The burner
will ignite. Adjust control knob to the desired setting. On
initial usage you may have to repeat this ignition function
several times (to allow air to be purged from the gas
supply system). No adjustment should be necessary. If
any problem occur, refer to the servicing instructions or
the fault finding chart.
• Ensure the manual is left with the user. If any of the above
procedures do not produce satisfactory results, the agent
service department should be consulted for more
specialized assistance.
• This gas hob has been tested for operating on town gas
pressure up to 31 mbar
• Gas connection
• The supply hose must be visible for its entire length (max.
one meter) and must be secured with a hose clamp X (Fig
8). The sealing washer must be fitted.
IMPORTANT SAFETY INSTRUCTION:
Upon completion of gas installation connections, it is
compulsory to check for gas leakage at the joint. (Soap test)
MODEL:EHG735SP
Fig.7 (in mm)
Bench cut-out size viewed from front of bench, i.e. control panel at front.
If clearance between side/back walls and periphery of the burner
is less than 200mm, the walls must be protected with
non-combustible material. The protection must extend a
minimum distance of 450mm above the burner. Horizontal
surfaces less than 750mm vertically above the hob must also be
protected.
Soap test procedure
•Turn the burner controls off and turn on the gas supply.
•Apply soapy solution to each joint. (Figure 8)
•Formation of bubbles indicates leakage and must be tightened.
•Repeat soap test
Advertisement
Table of Contents
