Table of Contents
Advertisement
installation
Table 2
Cooktop dimensions
width (mm)
depth (mm)
height (mm)
Cut-out dimensions
width (mm)
depth (mm)
This appliance must be installed by an authorised person and
in compliance with:
1. AS/NZS 5601.1 Gas Installations Part 1: General
Installations, and AS/NZS 5601.2 Gas Installations
Part 2: LP Gas installations in caravans and boats for non-
propulsive purposes, or the relevant installation code for
gas appliances in your country.
2. The local gas fitting regulations, municipal building
codes, electrical wiring regulations and any other relevant
statutory regulations.
3. The particular instructions as given below. Before
commencing installation, check to ensure that the
appliance gas type given on the data plate on the
appliance corresponds with the type of gas to which it
is intended the applance be connected.
4. A certificate of compliance MUST be given to the
customer after the application is successfully installed.
Installation procedure
1. The bench cutout should be made as per cutout
dimensions in Table 2 and Figure 4.
2. Adjacent walls, cupboards and protection for combustible
materials: Ensure that the appliance is installed in
accordance with clauses 6.2.5 and 6.10.1.1 of
AS/NZS 5601.1, or clauses 6.9.1 and 6.9.5 of
AS/NZS 5601.2 with regard to clearances to
combustible surfaces and materials, and clearances
to rangehoods and exhaust fans.
To ensure clearances of 200mm from burners to vertical
combustible surfaces observe the minimum distance
requirements shown in Figure 5.
Clearances to combustible surfaces may be reduced if
combustible surfaces are protected in accordance with
clause 6.10.1.2 of AS/NZS 5601.1, or clause 6.9.2 of
AS/NZS 5601.2.
3. Optional barrier: A barrier can be installed to prevent
accidental contact with the cooktop base, where the
base of the cooktop is accessible from below (i.e. Inside
a cupboard, etc.). An impression has been incorporated
into the base to ensure a minimum clearance of 10mm is
maintained between the base and the barrier. This barrier
may be made of any rigid material.
Square
Rectangular
600
860
535
510
58
58
570
830
490
470
Barrier protection is not necessary if the product is
installed above an underbench oven or similar appliance
and/or if the cupboard construction is such that the
underside of the cooktop is not accessible.
Figure 4
130mm min
570mm
135mm
min
830mm
Figure 5
110mm
115mm
37mm
130mm min
490mm
19mm
gas supply
connection
27mm
120mm min
470mm
19mm
gas supply
connection
wall
Gas Cooktops INSTALLATION 7
Hide quick links:
Advertisement
Table of Contents
