Power On / Off - Eiki LC-XDP3500 Owner's Manual

Setting Up

Power ON / OFF

Focus ring
POWER indicator
AC inlet
1.
Power off?
2.
Please press
key again to power off.
3.
Zoom ring
Outlet
4.
10
Turning On The Power
1. M ake sure that power cord is firmly and
correctly connected to the projector.
2. The POWER indicator will light up in green.
3. Press POWER button on the control panel or
the remote control to turn on the projector.
4. Rotate the zoom ring to adjust the screen size.
5. Rotate the focus ring to adjust the focus.
WARNING
A strong light is emitted when the projector's

power is on. Do not look into the lens of the
projector or look inside of the projector through
any of the projector's openings.
Turning Off The Power
1. Press the POWER button on the control
panel or the remote control. The "power off"
confirmation message appears.
2. Press the POWER button again while the
message appears.
3. When the projector enters "Standby" mode,
the POWER indicator will light up in green.
4. If you don't use the projector, remove power
cord.
WARNING
Do not touch around the lamp cover and the

exhaust vents during use or just after use, since it
is too hot.
CAUTION
Do not turn off the AC power for 60 seconds

after the lamp is turned on. Doing so could cause
premature lamp failure.