Log Set Installation - Travis Industries DVS GSR Insert Owner's Manual

22

Log Set Installation

! The logs are fragile, especially after being exposed to heat.

Make sure the gas control valve is "OFF" and the heater is cool prior to conducting service.

Failure to position the parts in accordance with these diagrams or failure to use only parts
specifically approved with this appliance may result in property damage or personal injury.

If using propane (LP), convert the appliance before installing the logs (see page 45).

The burner must be correctly positioned before installing the logs. Make sure the burner is fully
seated and the pilot is properly aligned. See page 45 for details on burner removal.
Ember Placement
Place a layer of embers along any visible edges of the burner.
Rear Log Placement
The rear log has two holes on the bottom. Place the log so the pins on the burner insert into the
holes on the log (see photos below).
© Travis Industries
Finalizing the Installation
4090812 100-01232_001