Download Print this page

Travis Industries 564 HO DancingFyre Installation Instructions Manual

Advertisement

Quick Links

Packing List
Rear Fireback
The log set includes:
Rear Log
Left Log
Right Log
Left Twig
Right Twig
Center Twig
Installation Tips
If using propane (LP), convert the appliance before installing the burner.
Installation Warnings
The logs are fragile, especially after being exposed to heat.
Make sure the gas control valve is OFF and the heater is cool before servicing.
Failure to position the parts in accordance with these diagrams or failure to use only parts
specifically approved with this appliance may result in property damage or personal injury.
The burner must be correctly positioned before installing the logs. Make sure the burner is
fully seated and the pilot is properly aligned.
Page 1 of 11
564 HO DancingFyre Burner
Installation Instructions
Burner
Burner Support Bracket
Fireback Floor
17601661 — 9/22/11
Side Firebacks
LS-43 Log Kit
Intake Restrictor
(sku: 96900114)
Rockwool
Embers
Log Spacers
Grate Assembly
Andiron Clips
© Travis Industries, Inc.

Advertisement

loading

Summary of Contents for Travis Industries 564 HO DancingFyre

  • Page 1 564 HO DancingFyre Burner Installation Instructions (sku: 96900114) Packing List Rear Fireback Rockwool Side Firebacks Embers LS-43 Log Kit Log Spacers Burner Burner Support Bracket Grate Assembly Intake Restrictor Fireback Floor Andiron Clips The log set includes:  Rear Log ...
  • Page 2 564 HO DancingFyre Burner Installation Instructions (sku: 96900114) Andiron Clips NOTE: Two andiron clips are included for those installations using andirons. See directions below to install. 11/32" Nutdriver 5/32 Hex Wrench Figure 1: Andiron Clips Installation Page 2 of 11 17601661 —...
  • Page 3: Burner Installation

    564 HO DancingFyre Burner Installation Instructions (sku: 96900114) Burner Installation 1. Remove both accent light assemblies from the brackets at the rear of the firebox (save the screws). Place the accent light assemblies in the center of the firebox floor, as shown below.
  • Page 4 564 HO DancingFyre Burner Installation Instructions (sku: 96900114) 3. Install the burner support bracket at the left side of the firebox, as shown below. Figure 5: Burner support bracket screws location Figure 6: Burner support bracket installed 4. Install the fireback floor into the firebox, as shown below.
  • Page 5 564 HO DancingFyre Burner Installation Instructions (sku: 96900114) 5. Install the rear, left, and right firebacks as shown below. Remove the clip located on the firebox ceiling near the front (both sides). The side fireback clip has a keyhole slot. It can be removed by loosening the screw and sliding the clip out.
  • Page 6 564 HO DancingFyre Burner Installation Instructions (sku: 96900114) 6. Re-attach the accent lights to the brackets at the rear of the firebox. Figure 7: Accent lights screws location Figure 8: Accent lights attached 7. Install the burner inside the firebox. Make sure the burner is fully seated and level with the fireback floor.
  • Page 7: Log Installation

    564 HO DancingFyre Burner Installation Instructions (sku: 96900114) 9. Install the logs into the firebox, following the instructions below. Log Installation Log Spacers Placement 1. Place the right log spacer on the burner as shown below. 2. Place the rear log spacers on the burner as shown below.
  • Page 8 564 HO DancingFyre Burner Installation Instructions (sku: 96900114) Left Log Placement 4. Place the left log as shown below, with the two holes in the bottom fitting over the pin on the burner and metal bracket attached to the pilot assembly.
  • Page 9 564 HO DancingFyre Burner Installation Instructions (sku: 96900114) Left Twig Placement 6. Place the left twig as shown below, with the twig pointing toward the center of the firebox. The left twig has a single hole on the bottom that fits over the pin on the rear log.
  • Page 10 564 HO DancingFyre Burner Installation Instructions (sku: 96900114) Center Twig Placement 8. Place the center twig directly on the burner as shown below. Make sure it does not cover any burner holes. Rock Wool Installation 9. Place the included rock wool on top of the burner to enhance the glow from the burner.
  • Page 11 564 HO DancingFyre Burner Installation Instructions (sku: 96900114) Ember Placement 10. Place a layer of embers along the edges of the burner, rivets, and fireback floor to enhance the aesthetics of the firebox. Do not place embers over any burner holes. See the photos below.

This manual is also suitable for:

96900114