Advertisement
Log Set Installation
!
The logs are fragile, especially after being exposed to heat.
•
Make sure the gas control valve is "OFF" and the heater is cool prior to conducting service.
•
Failure to position the parts in accordance with these diagrams or failure to use only parts
specifically approved with this appliance may result in property damage or personal injury.
•
If using propane (LP), convert the appliance before installing the logs.
•
The burner must be correctly positioned before installing the logs. Make sure the burner is fully
seated and the pilot is properly aligned.
Right Log Bracket
Bend the log bracket up to 90° as shown below.
Rear Log Placement
The rear log has two obround holes on the bottom. Place the log so the pins on the burner insert into the
holes on the log (see photos below). Once in place, carefully pull the log all the way forward. This allows the
log to glow above the rear burner holes. NOTE: If you encounter sooting on the rear log, move the log back
until sooting is eliminated.
Page 2 of 6
DVL Ember-Fyre Burner
Installation Instructions
17601695.docx — 11/19/13
(SKU 96900107, 96900109)
© Travis Industries, Inc.
Advertisement
