Advertisement
5. Install the rear, left, and right firebacks as shown below.
STAINLESS STEEL WARNINGS
HANDLING THE FIREBACKS: The stainless steel firebacks are shipped in vinyl to prevent marring the surface
of the stainless steel. Remove the vinyl prior to installation. Wear clean gloves when installing the firebacks
to prevent fingerprints on the surface (or use a rag or paper towel to handle the firebacks).
COLORATION AND CLEANING: These stainless steel firebacks will obtain a slight "patina" (brown tint) after
use. Do not clean the firebacks. This patina becomes consistent. Any cleaning may lead to unequal coloring.
If soot forms on the fireback, we recommend brushing it off with a soft cloth or brush.
Replace the fireback clips shown in step "A" after installing the firebacks.
Page 4 of 6
564 HO DiamondFyre Burner
Installation Instructions
Remove the clip located on the
a
firebox ceiling near the front (both
sides). The side fireback clip has
a keyhole slot. It can be removed
by loosening the screw and
sliding the clip out.
1/4" Nutdriver
17601656 — 8/21/13
(sku: 96900115)
© Travis Industries, Inc.
Advertisement
