Rear Panel - Strong SRT 5005 User Manual

1. Mode indicator
The RED light indicates that the receiver is in STAND-BY mode.
The GREEN light indicates that the receiver is in AWAKE mode.
2. 4 Digits display 1
In STAND-BY mode indicates current time.
In AWAKE mode indicates current channel number.
1
Only in models SRT 5010 and SRT 5015

7.2 Rear Panel

1. ANT IN
Use to connect a general Aerial Antenna for receiving broadcasting signal.
2. To TV
This gives you the possibility to connect a TV set in order to receive analogue channels or to
an extra receiver. (Includes modulator output in the model SRT 5015).
3. TV SCART Connector
Use this connector to connect your receiver with your TV set using a SCART cable.
4. VCR SCART Connector
Use this connector to connect your receiver to your video recorder using a scart cable. Your
video signal will now be looped through the receiver and your video recorder to your TV set.
5. S-VHS 2
Use this connector to connect your receiver to your TV and VCR using S-Video cable for better
picture quality.
6. Power Cord
Your receiver requires a current of 90 ~ 240 V AC (Auto-selectable), 50 ~ 60 Hz +/-5%.
Make sure to check the power specification before connecting your receiver to the wall outlet.
7. S/PDIF Digital audio output
Use this coaxial output to connect your receiver to the input of your digital audio amplifier.
8. RS 232 Serial Port
This serial port can be used to connect your PC with your receiver, and allows you to
download new versions of software to your receiver.
9. Power ON/OFF Switch
1 Only in models SRT 5010 and SRT 5015
2
Only in model SRT 5015
8
FIGURE 6. Real Panel
1
1
PART 1 English