Installing An At-8401 Management Card; Procedure For Installing A Management Card - Allied Telesis AT-8400 Series Reference Manual

Installing an AT-8401 Management Card

Procedure for
Installing a
Management
Card
This section describes how to install an AT-8401 management card in
the AT-8400 chassis. Use this procedure when the chassis is powered
down. You can install a maximum of one management card in an
AT-8400 chassis.
For information about replacing a management card, see
AT-8401 Management Card
To install an AT-8401 management card, perform the following
procedure:
Caution
Before installing a management card, refer to
Technical Specifications
mation.
1. Unpack the new management card from its shipping container and
store the packaging material in a safe location.
Be sure to observe all standard electrostatic discharge (ESD)
precautions, such as wearing an antistatic wrist strap, to avoid
damaging the device.
2. Check that the card package includes all the items listed in the
Verifying Package Contents section in this chapter. If any item is
missing or damaged, contact your Allied Telesyn sales representative
for assistance.
Keep the shipping material. You must use the original shipping
material if you need to return the card to Allied Telesyn.
AT-8400 Chassis Installation Guide
on page 52.
on page 97 for safety and emissions infor-
Replacing an
Appendix A,
47