Power Supply Connectors - Allied Telesis AT-8400 Series Reference Manual

AT-8400 Chassis Installation Guide

Power Supply Connectors

The chassis of an AT-8400 Series Switch is either AC powered or DC
powered. An AC powered chassis has two AC power sockets on the back
panel (see Figure 3 on page 4). A DC powered chassis has two DC
terminal blocks on the back panel (see Figure 4 on page 5). One power
connector is used for the pre-installed power supply. The other is for the
optional redundant power supply. For instructions on how to connect
power to an AC powered chassis, refer to Powering on an AC Chassis on
page 85. For instructions on how to connect power to a DC powered
chassis, refer to Powering on a DC Chassis on page 86.
13