Asus P2B-D User Manual page 91

5
Press S to skip mass storage device detection. This allows you
to manually select the driver for your host adapter.
6
Since mass storage device detection was skipped in the
previous step, Windows NT Setup displays none in the list of
recognized devices. Press S to configure additional SCSI
adapters.
7
From the list of additional SCSI adapters, expand the list, select
Other, and press Enter (requires disk provided by a hardware
manufacturer).
8
Insert the Adaptec 7800 Family Manager Set diskette for
Windows NT into drive A and press Enter.
The screen displays the adapter drivers supported on the
diskette. For Windows NT 3.5x, the following is displayed:
Adaptec AHA-290x/291x/294x/4944/AIC-78xx PCI SCSI
Controller (NT 3.5x)
or
Adaptec AHA-294xu2/AIC-7890/91 PCI Ultra2 SCSI Controller
(NT 3.5x)
9
Highlight the driver and press Enter.
10
To add other host adapters that are not a part of the 7800
Family, do so at this time by repeat from step 7 for each
additional adapter and insert the appropriate driver disk. The
Adaptec 7800 Family host adapters use the same driver; it is
not necessary to install the driver again.
11
Press Enter to continue with the Windows NT operating
system setup. Follow the instructions given onscreen and in
the Windows NT installation documentation.
Microsoft Windows NT Installation
2-3