Asus P2B-D User Manual page 125

Option Values
multlun_targets 00-FFFF
read_after_write 0-1
1
removable= on, off
start_unit 0-FFFF
tag_disable 0-FFFF
Novell NetWare Installation
Default Description
FFFF A bit mask to enable LUNs
on selected targets. By
default, LUNs on all
targets are enabled. This
bit mask is entered in hex
(see Bit Mask Options on
page 4-12).
1 Specifies default verify
mode; 0 = Off (No verify
on writes), 1 = On
(Hardware verify).
on Enables/disables support
for removable media other
than CD-ROMs. By
default, removable media
is supported. You may
want to disable removable
disk support in order to
load an ASPI Removable
Disk Module.
0 A bit mask to enable
sending the Start_Unit
command to specific
targets. By default, the
command is not sent to
any target. This feature is
not needed by most
devices. This bit mask is
entered in hex (see Bit
Mask Options on
page 4-12).
0 A bit mask to disable
tagged queuing for
specific targets. By default,
tagged queuing is enabled
for all targets. If bit mask is
set, then tagged queuing
for that particular device is
disabled. This bit mask is
entered in hex (see Bit
Mask Options on
page 4-12).
4-9