Asus P2B-D User Manual page 20

Installing the Pentium II Processor
1. Connect the Heat Sensor Cable to JP4/JP5 (optional): If you purchased the
specially designed fan and thermal monitor heatsinks, you may connect the heat
sensor cables to the motherboard's CPU heat sensor connectors (JP4/JP5) now.
NOTE: If you are installing only one processor, you may use JP5 to connect a
heat sensor cable to monitor the power supply temperature to make sure that it is
operating at a safe heat level. This feature is available only with the hardware
monitor installed.
P2B-D/DS CPU Heat Sensor Connectors
2. Insert the Attach Mount Screws: Insert the screws through the motherboard's
underside at the location indicated. Press the screws gently but firmly until it is
fully inserted. Do not rock the screws side to side, instead press the screws straight
into the holes.
Rib
Rib
20
III. INSTALLATION
Heat Sensor Connector for CPU 1
Heat Sensor Connector for CPU 2
Single Edge Contact Slot for CPU 1
Single Edge Contact Slot for CPU 2
ASUS P2B-D/P2B-DS User's Manual
JP4
JP5
NOTE: Insert the
screws into the
encircled areas.