Protection; Mains - Lyngdorf Audio TDA 2200 Owner's Manual

Parameter
DAC Out impedance
Input sensitivity
Power Supply Variation
Output connectors
Output power, 8ohms
Output power, 4ohms
Nominal load impedance
Frequency response
Frequency response
Frequency response
Output impedance
Output impedance
THD+N, 1W/8ohms
THD+N, 1W/4ohms
THD+N, 100W/8ohms
THD+N, 180W/8ohms
THD+N, 375W/4ohms
S/N ratio
Dynamic range
Channel separation
Peak output current
Output common mode voltage Max 33V DC
Output DC voltage
All audio measurements, except frequency response, are measured with a 20KHz low-
pass filter in accordance with AES-17.

Protection

Parameter
Grounding
Output short circuit current
Output DC voltage
Over temperature

Mains

Parameter
Mains input connector
Mains voltage range
Value
75 Ohm
4.4V (2.2V with high sens.)
26dB
4 insulated binding posts, gold-
plated.
2*200W
2*375W
4 Ohms-8 Ohms
0.3Hz-33KHz
-0dB/+0.2dB
-0.2dB/+0dB
0.035 Ohms
0.4 Ohms
0.015%
0.02%
0.008%
0.01%
0.07%
107dB
133 dB
90dB
±40A
±5 mV
Value
Mains earth, chassis and audio
ground are connected
internally.
±40A
±5V @ <0.1Hz
All heat sinks and mains-
transformer.
Value
IEC 320 cold type
100-120V AC, 50–60Hz
- 20 -
Note
Gain According to volume
control setting. 89 dB = 0 dB
with sensitivity normal and rel.
volume 0 dB
200W/8ohms/89 dB Volume
65V to 3.3V dep. On Volume
Will accept bare wire ends of
up to 5 mm diameter.
1KHz, 0.1% THD+N
1KHz, 0.1% THD+N
It is safe to operate the
amplifier with no load.
-3dB points, 8ohms load.
20Hz-20KHz, 8ohms load
20Hz-20KHz, 4ohms load
20Hz-1KHz
20KHz
A-wgt.
A-wgt.
A-wgt.
A-wgt.
A-wgt.
A-wgt. Ref. 200W/8ohms.
A-wgt. Ref. 200W/8ohms.
1KHz, 200W/8ohms.
Ref. Ground. The amplifier can
not be used in bridged mono
mode.
Note
Auto resetting thermal fuse in
mains transformer.
Note
Mains lead supplied.
115V version