Protection; Mains; Trigger; Mechanical - Lyngdorf Audio SDAI 2175 Owner's Manual

Parameter
S/N ratio
Channel separation
Peak output current
Output common mode voltage 35V DC
Output DC voltage
All audio measurements, except frequency response, are measured with a 20 kHz low-
pass filter in accordance with AES-17.

Protection

Parameter
Grounding
Output short circuit current
Output DC voltage
Over temperature

Mains

Parameter
Mains input connector
Mains voltage range
Mains voltage range
Internal mains fuse
Internal mains fuse
Power consumption
Power consumption
Power consumption
Power consumption

Trigger

Parameter
TRIGGER OUT connector
TRIGGER OUT Voltage

Mechanical

Parameter
Width
Depth
Depth
Height
Height
Net weight
Value
113dB
84dB
±40A
±5 mV
Value
Mains earth, chassis and audio
ground are connected
internally.
±40A
±5V @ <0.1Hz
All heat sinks and mains-
transformer.
Value
IEC 320 cold type
100-120V AC, 50–60Hz
200-240V AC, 50-60Hz
8 Amp
4 Amp
1.5 W
35 W
116 W
820 W
Value
3.5mm (1/8") mono jack
12V DC
Value
450mm (17.72")
340mm (13.39")
361mm (14.21")
88.8mm (3.5")
100.6mm (3.96")
15.5Kg (34lb.)
- 16 -
Note
A-wgt. Ref. 200W/8ohms.
1kHz, 200W/8ohms.
Ref. Ground. The amplifier can
not be used in bridged mono
mode.
Note
Auto resetting thermal fuse in
mains transformer.
Note
Mains lead supplied.
115V version
230V version
115V version
230V version
STANDBY mode.
OPERATE mode, no output.
2*37.5W/4ohms.
2*300W/4ohms.
Note
Case=Gnd, Tip=Input
Short circuit protected
Note
Excluding loudspeaker
connectors.
Including loudspeaker
connectors.
Excluding feet.
Including feet.