Replacing Gobos - Elation Power Spot 575IE II User Manual

Lighting fixtures

Table of Contents

Power Spot 575IE II™

11. CHANGING/REPLACING GOBOS

The POWER SPOT 575IE II™ is fitted with a standard size gobo wheel that accepts

gobos with an outside diameter of 26.9mm and a viewable image size of 23mm. Glass or

steel gobos may be used. Please follow the safety procedures and installation below for

proper and pain gobo exchange. Please refer to the specification section at the end of

this manual for exact gobo specifications!

S afety R egulations

• Always disconnect the main power supply!

• If the unit was recently in operation, be sure to allow the unit a minimum of 20

minutes to cool before opening the unit.

• To avoid eye injury and reduce exposure to UV radiation always be sure to

replace the protective outside casing before attempting operation.

1.1 Installing/Replacing Gobos

1.1.1 Always be sure to disconnect the main power supply before attempting any

service.

1.1.2 Remove the upper shell of the protective cover by removing the 4 retaining

Phillips screws, 2 located on the front and 2 located on the rear of the head.

1.1.3 Once the outer cover has been removed;

a) Fixed Gobo Wheel; Rotate the gobo wheel to a position that allows easy

access to the gobo you want to replace. Using a small flat-head

screwdriver, gently pry out the gobo retaining spring.

b) Rotating Gobo Wheel; The rotaing gobo wheel uses a unique quck-

change system. To remove a gobo, genetly pull up on the gobo holder

and pull out. Refer to the illustration on the next page.

1.1.4 Replace the gobo and reinsert the retaining spring to secure the new gobo in

place. Be sure the retaining spring is insert properly to avoid damage to the

wheel.

1.1.5 R eas s em ble the P O WE R S P O T 575IE II ™ in rev ers e order.

wwww.ElationLighting.com

Page

Table of Contents