Table of Contents
Advertisement
Power Spot 575IE II™
DFSE
FEED
EFLG
6.1 S etting/C hanging the D MX A ddres s
After applying power to the P O WE R S P O T 575IE ™ the LED will display the fixture's
current DMX address immediately after the reset sequence. If the fixture is not
receiving a DMX signal the display will flash continuously.
D001
To set or adjust a DMX address, please follow the procedure below:
1. Switch on the P O WE R S P O T 575IE ™ and wait for the fixture reset process to
RESE
finished ('
2. Press the Mode button to access the main menu. Toggle through the menu by
pressing the U p and D own buttons until the display shows
button to make changes to the address, the current three digit address will
immediately begin to flash.
3. While the current three-digit address is flashing, use the U p and D own buttons to
select adjust the address. Lock your new address into the unit's memory by
pressing the E nter button. After the new address has been successfully stored
into the fixture's memory the LED will briefly readout
The DMX address is non-destructible and will remain in the fixture's memory even
when the power has been switched off. Memory is backed-up and retained by an
internal power source with a five year shelf life.
6.2 Tes t P rogram
Test
The Tes t Program engages the fixture's internal test mode. This function runs a
complete test procedure of all functions. Press E nter to launch the self-test or the
Mode button to cancel and return to the main menu.
©Elation Professionals® Los Angeles, Ca.
clre
Clears internal memory (technician only)
ares
Adjust Reset (wheels static after reset)
VTIL
Software version, tilt pc-board
VTR1
Software version, driver board 1
VTR2
Software version, driver board 2
VTR3
Software version, driver board 3
Call on the default function values
Pan/Tilt feedback (error correction) On/Off
Correction of faults
' will flash in the LED while fixture is in reset mode).
OK
-
wwww.ElationLighting.com
D001
. Tap the enter
.
20
-
Page
Advertisement
Table of Contents
