Switching On And Off - Sim2 SUPERLUMISEC User Manual

Charging the battery
The glasses are shipped with the micro USB to USB Type A cable. To charge the glasses
battery, plug the micro USB cable in a computer or other USB device capable of
supplying power. LED will remain lit while glasses are charging. When battery is fully
charged LED will go off.
For more information on glasses status and transitions, refer to "3D Glasses" on page
21.
Distances from glasses to 3D RF Emitter
The minimun distance from glasses to 3D RF Emitter is 10 m, the maximun depends
on how the room is made.
AC Power
Choose the AC power cord that is appropriate in your area among those shipped with
the product. Plug the female end of the power cord to the AC receptacle located on
the right hand side of the projector (100-240 V AC, 50-60 Hz) and the other end into a
grounded AC outlet. An high-quality surge protector is recommended while a UPS is
optional.

Switching On and Off

Switching On
1. Turn on the main power switch on the right hand side of the projector. The
projector enters the low power Standby status. The indicator light on the left
hand side of the projector turns red and the status display next to it shows . .
2. Press any of the numeric keys (0-9) on the remote control or the I/O button
on the projector keypad to switch on the projector.
3. The indicator light turns green and red and the status display shows 88 for a
while.
4. When the projector is ready for use an image appears on screen (this can take
approximately one minute).
5. If a valid signal is detected, an image appears on the screen, otherwise a black
screen with a "No Signal" message is displayed.
Switching Off
1. Press and hold the Off key on the remote control or the I/O button on the
projector keypad.
The indicator light flashes green and red to indicate that the projector is
cooling down. Cooling fans remain on for approximately four minutes to cool
the lamp. In the meanwhile the projector cannot be turned on again.
2. After cooling is complete the projector enters Standby status. The indicator
light turns solid red and the status display turns black, unless an error or
warning code is displayed.
Warning: Wait for the cooling fans to turn off before turning off the main power
switch or unplugging the projector.
3 Installation SUPERLUMIS 19
User Guide