11
MAINTENANCE WORK ON THE CHASSIS
11.11
Adjusting the play of the steering head bearing
11.12
Greasing the steering head bearing
Main work
–
Move the handlebar to the straight-ahead position. Move the fork legs to and fro in
the direction of travel.
No play should be noticeable in the steering head bearing.
»
If there is noticeable play present:
–
Adjust the play of the steering head bearing.
–
Move the handlebar to and fro over the entire steering range.
The handlebar must be able to move easily over the entire steering range. No
400738-11
resting locations should be noticeable.
»
If click positions are noticeable:
–
Adjust the play of the steering head bearing.
–
Check the steering head bearing and replace if required.
Finishing work
–
Remove the motorcycle from the lift stand. (
Preparatory work
–
Raise the motorcycle with a lift stand. (
Main work
–
Remove fuel tank breather
–
Loosen screws
–
Loosen screw
–
Loosen and retighten nut
Guideline
Nut, steering head
C00056-10
–
Using a plastic hammer, tap lightly on the upper triple clamp to avoid strains.
–
Tighten screw
Guideline
Screw, top triple clamp
–
Tighten screws
Guideline
Screw, top triple clamp
–
Position the fuel tank breather
Finishing work
–
Check play of steering head bearing. (
–
Remove the motorcycle from the lift stand. (
x
–
Remove the lower triple clamp.
–
Install the lower triple clamp.
400563-01
x
.
1
.
2
.
3
.
4
M20x1.5
.
3
.
2
.
1
(
p. 29)
x
x
(
p. 30)
(
p. 32)
x
x
(
p. 32)
p. 27)
p. 27)
No play
Only applies when
≤ 9 Nm
using:
(≤ 6.6 lbf ft)
Key for steer-
ing head bearing
(45229050000)
M8
20 Nm
(14.8 lbf ft)
M8
20 Nm
(14.8 lbf ft)
p. 31)
p. 27)
32