Checking Rear Brake Fluid Level; Adding Rear Brake Fluid - KTM 50 SX 2012 Owner's Manual

Hide thumbs Also See for 50 SX 2012:
Table of Contents

Advertisement

12
BRAKE SYSTEM
12.14

Checking rear brake fluid level

Warning
Danger of accidents Failure of the brake system.
If the brake fluid level falls below the MIN mark, this indicates a leakage in the brake system or worn-out brake linings.
Check the brake system and do not continue riding. (Your authorized KTM workshop will be glad to help.)
Warning
Danger of accidents Reduced braking efficiency due to old brake fluid.
Change the brake fluid of the front and rear brake according to the service schedule. (Your authorized KTM workshop will
be glad to help.)
12.15

Adding rear brake fluid

Warning
Danger of accidents Failure of the brake system.
If the brake fluid level falls below the MIN mark, this indicates a leakage in the brake system or worn-out brake linings.
Check the brake system and do not continue riding. (Your authorized KTM workshop will be glad to help.)
Warning
Skin irritation Brake fluid can cause skin irritation on contact.
Avoid contact with skin and eyes, and keep out of the reach of children.
Wear suitable protective clothing and goggles.
If brake fluid comes into contact with the eyes, flush the eyes thoroughly with water and consult a physician immediately.
Warning
Danger of accidents Reduced braking efficiency due to old brake fluid.
Change the brake fluid of the front and rear brake according to the service schedule. (Your authorized KTM workshop will
be glad to help.)
Warning
Environmental hazard Hazardous substances cause environmental damage.
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
Detach the spring.
Loosen nut
Turn back push rod
For an individual adjustment of the basic position of the foot brake lever, loosen
the screw
Tighten screw
Guideline
Remaining screws, chassis
700489-01
Turn push rod
Guideline
Free travel of foot brake lever
Hold push rod
Attach spring.
Check whether the basic position of the foot brake lever is suitable for the rider.
Stand the vehicle upright.
Check the brake fluid level in the viewer
»
When an air bubble is visible in the viewer
Add rear brake fluid.
700490-01
x
.
1
until free travel is at a maximum.
2
and turn the eccentric brake lever stop
3
.
3
until clearance
is created.
2
A
and tighten nut
.
2
1
(
p. 51)
x
accordingly.
4
M6
10 Nm (7.4 lbf ft)
3... 5 mm (0.12... 0.2 in)
.
1
:
1
51

Advertisement

Table of Contents
loading

Table of Contents