Carburetor - Adjusting Idle Speed; 50 Sx Mini) - KTM 50 SX 2012 Owner's Manual

Hide thumbs Also See for 50 SX 2012:
Table of Contents

Advertisement

15
TUNING THE ENGINE
15.7

Carburetor - adjusting idle speed

Info
If the speed rise is too high, reduce the idle speed to a normal level and
repeat the preceding steps.
If the procedure described here does not lead to satisfactory results, the
cause may be a wrongly dimensioned idling jet.
If you can turn the idle adjusting screw to the end without any change of
engine speed, you have to install a smaller idling jet.
After changing the idling jet, start from the beginning with the adjusting
steps.
Following extreme air temperature or altitude changes, adjust the idle speed
again.

(50 SX Mini)

x
Screw in idle air adjusting screw
position.
Guideline
Idle air adjusting screw
Open
Run the engine until warm.
Guideline
Warm-up time
700522-01
Danger
Danger of poisoning Exhaust gases are toxic and inhaling them may result
in unconsciousness and/or death.
Adjust the idle speed with adjusting screw
Guideline
Choke function deactivated – The choke lever is pushed down all the way.
(
p. 14)
Idle speed
Turn idle air adjusting screw
begins to fall.
Note the position and turn the idle air adjusting screw slowly counterclockwise until
the idle speed falls again.
Adjust to the point between these two positions with the highest idle speed.
Info
If the engine speed rises considerably, reduce the idle speed to a normal
level and repeat the above steps.
If the procedure described here does not lead to satisfactory results, the
cause may be a wrongly dimensioned idling jet.
If you can turn the idle air adjusting screw to the end without any change of
engine speed, you need to install a smaller idling jet.
After changing the idling jet, start from the beginning with the adjusting
steps.
Following extreme air temperature or altitude changes, adjust the idle speed
again.
all the way and turn it to the specified basic
2
When running the engine, always make sure there is sufficient ventila-
tion, and do not start or run the engine in an enclosed space without an
effective exhaust extraction system.
slowly in a clockwise direction until the idle speed
2
1 turn
≥ 5 min
.
1
1,400... 1,500 rpm
64

Advertisement

Table of Contents
loading

Table of Contents