Mounting The Seat; Removing The Air Filter; Installing The Air Filter - KTM 50 SX 2012 Owner's Manual

11 MAINTENANCE WORK ON THE CHASSIS
11.20

Mounting the seat

11.21

Removing the air filter

Note
Engine failure Unfiltered intake air has a negative effect on the service life of the engine.
–
Never ride the vehicle without an air filter since dust and dirt can get into the engine and result in increased wear.
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
11.22

Installing the air filter

–
Hook the seat onto screw
Projection
601977-10
–
Close quick release
601976-11
x
Preparatory work
–
Remove the seat. (
Main work
–
Press the rear holding lugs
Pull out the front holding lug and take off the air filter cover.
–
Take off the air filter.
601975-10
x
Main work
–
Position the clean air filter.
–
Position the rear holding lug. Lower the air filter cover and allow the front holding
lug to snap in.
1
Info
If the air filter is not correctly mounted, dust and dirt can enter the engine
and cause damage.
601978-10
Finishing work
–
Mount the seat. (
and lower the seat at the rear while pushing it forward.
1
hooks into the fuel tank.
2
.
3
p. 34)
together slightly and swing the air filer cover upward.
1
p. 35)
35