Installing The Rear Brake Linings - KTM 50 SX 2012 Owner's Manual

12 BRAKE SYSTEM
12.18

Installing the rear brake linings

Warning
Danger of accidents Reduced braking efficiency due to oil or grease on the brake discs.
–
Always keep the brake discs free of oil and grease, and clean them with brake cleaner when necessary.
Warning
Danger of accidents Reduced braking efficiency due to use of non-approved brake linings.
–
Brake linings available from accessory suppliers are often not tested and approved for use on KTM vehicles. The construc-
tion and friction factor of the brake linings and therefore the brake power can differ considerably from the original KTM
brake linings. If brake linings are used that differ from the originals, there is no guarantee that they comply with the origi-
nal license. The vehicle no longer corresponds to the condition at delivery, and the warranty is no longer valid.
–
Remove the brake linings.
–
Clean brake caliper and brake caliper support.
700493-01
x
Preparatory work
–
Check the brake discs. (
Main work
–
Insert the brake linings.
Info
Ensure that the brake linings are correctly positioned in the holding spring.
700493-10
–
Mount screw
Guideline
Screw, brake linings
–
Mount lock washer
700494-01
Finishing work
–
Install the rear wheel.
(50 SX)
–
Install the chain guard. (
–
Remove the motorcycle from the lift stand. (
p. 46)
.
1
.
2
( p. 56)
x
p. 38)
M5 8 Nm (5.9 lbf ft)
p. 27)
53