Miter Gauge - Grizzly G0652 Owner's Manual

Miter Gauge

Tools Needed
hex Wrench 2.5mm ........................................... 1
phillips head screwdriver .................................. 1
machinist square ............................................... 1
adjustable square ............................................. 1
Wrench 8mm ..................................................... 1
To adjust the miter gauge so it is perpendicu-
lar to the saw blade:
1. slide the miter gauge into the miter gauge
slot to the left of the blade.
2. push in the shaft (figure 84).
Jam nut
stop screw
pointer
shaft
figure 84. miter gauge diagram.
3.
loosen the lock knob on the miter gauge and
place a square against the face of the miter
body and the blade.
g0651/g0652 10" extreme series table saws
4.
Qty
5.
6
7.
8.
9.
lock Knob
miter Body
set
screws
adjust the miter body until the pointer is at
0° and there is no space between the square
and the blade, then tighten the lock knob.
loosen the jam nut and adjust the stop screw
until it is seated against the shaft (see figure
84 for part locations), then tighten the jam
nut.
loosen the screw on the front of the miter
bar, adjust the pointer to 0°, then tighten the
screw.
to adjust to 45°, follow Steps 1-5 using an
adjustable square set to 45°.
double-check your adjustments at 45° and
90° to assure that you have accurately set
your miter gauge.
to adjust the sliding resistance of the miter
bar in the miter slot, turn the adjustment set
screws shown in figure 84 clockwise in small
increments, and test fit between adjustments
until the miter gauge fits your expectations.
-57-