Blade Selection - Grizzly G0652 Owner's Manual

Blade Tilt: to adjust the blade tilt, loosen the
blade tilt lock, turn the blade tilt handwheel to
position the blade at the desired angle, and tight-
en the lock shown in figure 35.
digital
Blade height
readout
lock
Blade height
handwheel
figure 35. Basic table saw controls.
Blade height: to set the blade height, unlock the
blade height lock, turn the handwheel to set the
blade height approximately
workpiece, then re-tighten the blade height lock.
fence Lock: after adjusting the fence to the
desired width of cut, lock it in place by firmly push-
ing the fence lock down until it stops.
Digital Readout: displays the current blade
angle when the handwheel is moved and power
is connected to the table saw. see page 53 for
setting the digital readout.
g0651/g0652 10" extreme series table saws
Blade tilt
lock
Fence
lock
Blade tilt
handwheel
⁄ " higher than the
1
4

Blade Selection

this section on blade selection is by no means
comprehensive. always follow the saw blade
manufacturer's recommendations to ensure safe
and efficient operation of your table saw.
Ripping blade features:
• Best for cutting with the grain of the
workpiece.
• 20-40 teeth.
• Flat-top ground tooth profile.
• large gullets for large chip removal.
figure 36. ripping blade.
crosscut blade features:
• Best for cutting across the grain of the
workpiece.
• 60-80 teeth.
• alternate top bevel tooth profile.
• small hook angle and a shallow gullet.
figure 37. Crosscutting blade.
-31-