Riving Knife; Table Insert - Grizzly G0652 Owner's Manual

Riving Knife

review this section, even if your saw riving knife
came pre-installed. you must install the riving
knife or the splitter and blade guard before operat-
ing the table saw.
To install the riving knife:
1.
disConneCt the saW From poWer!
2.
put on heavy leather gloves.
3.
remove the table insert, blade guard, and
splitter—if previously installed.
4. loosen the hex bolt (figure 25), insert the
riving knife into the bracket slot, and tighten
the hex bolt to secure the riving knife.
riving Knife
figure 25. riving knife installed.
5. install the table insert, as described in Table
Insert.
g0651/g0652 10" extreme series table saws
Bracket
hex Bolt

Table Insert

you must install the table insert before operating
the table saw.
To install and adjust the table insert:
1.
disConneCt the saW From poWer!
2. place the table insert into the table, then
place a straightedge across the table and the
table insert.
3.
use a 3mm hex wrench and straightedge to
adjust the table insert flush with the table as
shown in figure 26.
figure 26. adjusting the table insert.
the table insert must be flush with the table
top or the workpiece will hit the edge of the
table insert at the beginning of the cut.
4.
tighten the m5-.8 x 20 flat head screw shown
in figure 27.
figure 27. table insert screw.
Note: Do not overtighten the table insert
screw. If you have questions, contact
Technical Support.
table insert
screw
-25-