Blade Alignment; Adjusting Fence - Grizzly G0652 Owner's Manual

10. tighten down one bolt a small amount and
then move on to each of the others, tighten-
ing each down the same amount. Continue
to rotate through the bolts, tightening them a
little each time until they are all secure.
11. now recheck the blade to miter slot at 90°
and 45° by repeating Steps 2-6. if the dis-
tance of a and B are equal, continue to the
Blade Alignment procedure. if the distances
are still off, repeat Steps 9-11.
12. once you feel you have the miter slot adjust-
ed to the blade, recheck all measurements
and be sure the table mounting bolts are
secure. also, if you ever remove the table
in the future, be sure to make note of shim
placements and reassemble exactly how it
came apart.

Blade Alignment

if the blade contacts the table insert when raised
or tilted, the blade must be aligned by moving the
table.
Tools Needed
Wrench 14mm ................................................... 1
To adjust the blade alignment by moving the
table:
1.
disConneCt the saW From poWer!
2. loosen the three table mounting bolts (page
54, figure 78) and adjust the table until the
blade does not contact the insert. tighten all
the mounting bolts.
3. make sure the blade does not contact the
table insert when raised or tilted. recheck
parallelism of the blade to the miter slot (see
page 53). adjust as necessary until the blade
does not touch the insert.
g0651/g0652 10" extreme series table saws

Adjusting fence

the rip fence included with your model g0651/
g0652 table saw is designed to provide excellent
ripping accuracy when properly adjusted. there
are four main adjustments: square, height, paral-
lelism, and clamping pressure. Keep in mind that
these adjustments are interconnected and some
trial-and-error may be needed to achieve satisfac-
tory results.
Tools Needed
hex Wrench 4mm .............................................. 1
hex Wrench 6mm .............................................. 1
machinist square ............................................... 1
Square and height
adjust the the nylon screws (figure 81) on top of
the fence bracket with a 6mm hex wrench to set
the fence square with the blade and set the fence
height above the table.
screws
Qty
figure 81. nylon adjustment screws.
place a machinist's square on the table against
the side of the fence. if the square does not
remain flush against both the fence and the table,
adjust the nylon screws until the fence and table
are square.
if the bottom surface of the fence is more than
/ " above the table at the front or back, adjust the
1
16
fence height using the nylon screws and the rear
rail foot (figure 81).
nylon
rear rail
Fence
Bracket
Qty
Foot
-55-