Saw Blade; Blade Guard And Splitter - Grizzly G0652 Owner's Manual

Saw Blade

The saw blade is extremely sharp. use extra
care when handling the blade or working
near it. Serious injury is possible.
review this section, even if your saw blade came
pre-installed.
To install the blade:
1.
disConneCt the saW From poWer!
2.
put on heavy leather gloves.
3.
remove the table insert, blade guard, and
splitter–if previously installed.
4.
use the arbor wrenches to loosen and remove
the arbor nut, flange, and blade.
Note: The arbor nut has right hand threads;
turn it counterclockwise to loosen.
5. slide the blade over the arbor with the teeth
facing the front of the saw, as shown in
figure 23.
Front of saw
figure 23. Correct blade direction.
6. re-install the arbor flange and the arbor nut,
and tighten them against the blade with the
wrenches included with the saw. do not
overtighten.
-24-
teeth direction
& Blade rotation
Blade Guard and
Splitter
you must install the blade guard and splitter
before operating the table saw.
To install the blade guard:
1. disConneCt the saW From poWer!
2.
put on heavy leather gloves.
3.
raise the blade up all the way.
4.
using an arbor wrench, loosen the hex bolt
shown in figure 24.
splitter
pawls
figure 24. Blade guard and splitter installed.
5. insert the splitter into the bracket slot, and
tighten the hex bolt to lock the splitter.
6. lift up on the splitter pawls and install the
table insert (see Table Insert, page 25).
g0651/g0652 10" extreme series table saws
Bracket
hex Bolt