On/Off Switch; Miter Gauge - Grizzly G0652 Owner's Manual

On/Off Switch

to install the switch, fasten the switch to the left
end of the front rail with two m8-1.25 x 12 hex
bolts, flat washers and lock washers, and install
the anti-start safety pin as shown in figure 28.
x 2
anti-start
safety pin
figure 28. switch installed.
-26-
to assemble the miter gauge, install the miter
gauge handle and 8mm flat washer onto the miter
gauge as shown in figure 29. slide the miter
gauge into the miter gauge slot to the left of the
blade; or store it temporarily on the brackets near
the blade angle handwheel.
stop paddle

Miter Gauge

handle
Washer
figure 29. miter gauge installed.
g0651/g0652 10" extreme series table saws