Digital Readout; Miter Slot To Blade; Parallelism - Grizzly G0652 Owner's Manual

Digital Readout

the digital readout displays the current blade
angle. only set the readout after verifying that
the 90° and 45° blade tilt stops are correctly posi-
tioned.
To set the digital readout:
1.
ensure the power is connected and the 45°
and 90° stop bolts are set (see Blade Tilt
Stops on page 51).
2. move the blade angle to 0° and press the 0°
set button (figure 76) for several seconds
until the readout displays 0.00.
0° set Button
figure 76. digital readout.
3. move the blade angle to 45° and press the
45° set button for several seconds until the
readout displays 45.0.
Note: If you move the blade angle handwheel
when the power is disconnected, the digital
readout will be incorrect when the saw is
reconnected, and you will need to reset it.
g0651/g0652 10" extreme series table saws
45° set Button

Miter Slot to Blade

parallelism

Tools Needed
adjustable square ............................................. 1
metal shim stock .............................. as needed
marker ............................................................... 1
your table saw will give the best results if the
miter slot and the rip fence are adjusted paral-
lel to the blade. if either of these are not exactly
parallel, your cuts and your finished work will be
lower in quality, but more importantly, the risk of
kickback will be increased. take the time to adjust
your table saw properly. a few minutes now will
be time well spent.
Note: For safest and most accurate adjustments,
use a Superbar and Master Plate (see Figure 61
on Page 45).
To adjust the blade parallel to the miter slot:
1.
disConneCt saW From poWer!
2.
use an adjustable square to measure the
distance from the miter slot to a carbide tip on
the blade as shown in figure 77. make sure
that the face of the adjustable square is even
along the miter slot.
figure 77. example of adjusting blade to miter
slot.
Qty
-53-