Table of Contents
Advertisement
Blade Alignment
if the blade contacts the table insert when raised
or tilted, the blade must be aligned by moving the
table.
Tools Needed
Wrench 14mm ................................................... 1
To adjust the blade by moving the table:
1.
disConnECt thE saW From poWEr!
2.
loosen the three table mounting bolts (page
52) and adjust the table until the blade does
not contact the insert. tighten all the mount-
ing bolts.
3. make sure the blade does not contact the
table insert when raised or tilted. recheck
parallelism of the blade to the miter slot (see
page 52). adjust as necessary until the blade
does not touch the insert.
Adjusting fence
the rip fence included with your model g0605X/
g0606X/W1762 table saw is designed to pro-
vide excellent ripping accuracy when properly
adjusted. there are four main adjustments to
concern yourself with: square, height, parallelism,
and clamping pressure. Keep in mind that these
adjustments are interconnected and some trial-
and-error may be needed to achieve satisfactory
results.
Tools Needed
hex Wrench 4mm .............................................. 1
hex Wrench 6mm .............................................. 1
machinist square ............................................... 1
Square and height
adjust the the nylon screws (figure 80) on top of
the fence bracket with a 6mm hex wrench to set
the fence square with the blade and set the fence
height above the table.
-54-
screws
Qty
figure 80. nylon adjustment screws.
place a machinist's square on the table against
the side of the fence. if the square does not
remain flush against both the fence and the table,
adjust the nylon screws until the fence and table
are square.
if the bottom surface of the fence is more than
/
" above the table at the front or back, adjust the
1
16
fence height using the nylon screws and the rear
rail foot (figure 80).
clamping pressure and parallelism
the fence clamping mechanism can be adjusted
simultaneously to set the right amount of clamping
pressure to hold your fence securely, and ensure
the fence is parallel to the miter slot.
remove the fence and, using a 4mm hex wrench,
adjust the set screws shown in figure 81 equally
on the rear side of the front bracket.
Fence
Bracket
Qty
figure 81. set screw adjustments.
model g0605X/g0606X (mfg. since 11/06)
nylon
rear rail
Fence
Bracket
set
screws
Foot
Advertisement
Table of Contents
