Rimage DLN5200 User Manual page 24

Rimage DLN5200/DL5200
EVEREST PRINTER OPENING ERROR – The print drawer may be obstructed. Ensure that the
printer is seated properly on the printer mounting plate and ensure that the printer is aligned.
EVEREST PRINTER RAISE P.H. ERR. – Contact Rimage support.
EVEREST PRINTER RETRANSFER OUT – The retransfer ribbon is at the end of the roll and a
new retransfer ribbon must be installed.
EVEREST PRINTER RETRANSFER GONE – The retransfer ribbon is not installed. Install a
retransfer ribbon.
EVEREST PRINTER RIBBON OUT – The print ribbon is out and a new print ribbon must be
installed.
EVEREST PRINTER R.T. DOWN SENSOR – Contact Rimage support.
EVEREST PRINTER R.T. UP SENSOR – Contact Rimage support.
EVEREST PRINTER R.T. ROLLER FAIL – Contact Rimage support.
EVEREST PRINTER R.T. MOTOR FAIL – Contact Rimage support.
EVEREST PRINTER R.T. THERMISTOR – The retransfer roller thermister must be replaced.
Contact Rimage support.
EVEREST PRINTER SET SWITCH TO 1 – The Rimage autoloader detected the mode switch on
the Everest Printer is not set to position 1. Change the mode switch to position 1. After changing
the mode switch, the printer must be reinitialized. Use the following instructions:
•
If the autoloader is a DL5200, use the main power switch to power off the system. After ten
seconds, switch the main power switch to the 'on' position. Restart the PC so it will recognize
the recorders.
•
If the autoloader is a DLN5200, use the PC power button to power off the system. Switch off
the main power switch. Then switch on the main power switch and press the PC power
button to restart the system.
EVEREST PRINTER P.H. THERMISTOR – The print head thermister must be replaced. Contact
Rimage support.
18 110768_D