Section 3: Circuit Requirements; 110 Volt - Grizzly G0547 Instruction Manual

SECTION 3: CIRCUIT REQUIREMENTS

110 Volt

Amperage Draw
1
The Model G0547 ⁄
3
ate at 110V and will draw the following load:
Motor Load..............................................5 Amps
Plug Type
The Model G0547 is supplied with a NEMA 5-15
plug. DO NOT modify the plug or power cord in
any way. See Figure 1 for a NEMA 5-15 plug and
grounded outlet.
i
Figure 1. NEMA 5-15 plug and
grounded outlet.
-6-
HP motor is wired to oper-
Circuit Breaker Requirements
We recommend that the circuit you use your
machine on should be dedicated. Use the follow-
ing guidelines when choosing a circuit breaker for
your machine (circuit breakers rated any higher
are not adequate to protect the circuit):
Recommended Circuit Breaker ..............10 Amp
Your Circuit Capacity
Always check to see if the wires in your circuit are
capable of handling the amperage load from your
machine. If you are unsure, consult a qualified
electrician.
If you operate this machine on any circuit that is
already close to its capacity, it might blow a fuse
or trip a circuit breaker. However, if you are not
placing an unusual load on the machine and a
power failure still occurs, contact a qualified elec-
trician or our Service Department at (570) 546-
9663.
Serious personal injury could occur if you
connect your machine to the power source
before you have completed the assembly
process. DO NOT connect the machine to
the power source until instructed to do so.
G0547 Combo Sander