Adjusting Belt Angle; Installing Back Stop; Installing Sanding Belt - Grizzly G0547 Instruction Manual

Adjusting Belt Angle

To adjust the sanding belt angle:
1. Disconnect the machine from the power
source!
2. Loosen the cap screw shown in Figure 11.
Figure 11. Raising the sanding belt bed.
3. Raise the sanding belt to the desired angle
and tighten the cap screw.

Installing Back Stop

To install the back stop:
1. Screw a hex bolt, with a flat washer and a
lock washer on it, through the back stop and
into the hole shown in Figure 12.
2. Square the back stop as shown in Figure 12
and tighten the hex bolt.
Figure 12. Squaring the back stop
-16-
Installing Sanding
To install the sanding belt:
1. Disconnect the machine from the power
source!
!
2. Loosen the belt tension by pulling out the
tensioning lever shown in Figure 13.
Belt
Tensioning
Lever
3. Slide the belt onto the drive drums as shown
in Figure 13 and release the belt tensioning
lever.
Note—make sure that the arrow on the inside of
the sanding belt points the same direction as the
belt rotation arrow on the machine.
Belt
Figure 13. Installing belt.
G0547 Combo Sander
!