Install And Start Océ Power Logic; Install Océ Power Logic Controller Remote On Your System - Oce TC4 User Manual

Install and start Océ Power Logic
troller Remote
Install Océ Power Logic controller Remote on your system
Introduction
The Océ Power Logic controller Remote application can run on all platforms with Java™
Virtual Machine. This section describes the installation procedures for the different types
of platforms.
Before you begin
To install Océ Power Logic controller Remote on Windows ® 9.x, NT, ME, XP, or 2000,
your system must be at least equipped with a Pentium ® 233 with 32 Mb RAM.
Note:
The file name remlogic, used in the installation procedure below is an example. It can
occur that you need to use another name during the installation procedure.
Installation procedure for Microsoft
Insert the Océ Power Logic ® controller Remote CD-ROM or the Océ Power Logic ®
1.
controller CD-ROM into the CD-ROM drive of your PC.
The installation starts automatically. If it does not start automatically, run Setup.exe.
2.
Select the required language in the installation wizard and click 'OK'.
3.
Follow the instructions on the screen to complete the installation of Océ Power Logic ®
4.
controller Remote.
Note:
You can only use Océ Power Logic controller Remote when TCP/IP is enabled on your
system. Ask your system administrator for help with the installation procedure for TCP/IP.
Install Océ Power Logic controller Remote on your system
® ®
Windows platforms
Chapter 3 - Océ Power Logic
®
con-
®
controller Remote
67