Feature Setup; Noise Generator; Language - Classe Audio SSP-25 Owner's Manual

5.6

FEATURE SETUP

Feature setup includes two operating considerations, the reset to factory defaults and software version query. Using
the remote you can set the operation of the internal noise generator, pick the language you would like it to
communicate with, do a complete reset of all operations back to factory defaults, and get a readout of what version of
software is running on the processor. It is all very simple.
5.6.1

NOISE GENERATOR

Press "MENU", then press the ">" key twice to display "Main menu – System setup." Select this option by pressing
"ENTER", then press the ">" key four times to navigate to "System setup – Feature setup."
Press "ENTER" to select. The screen will read: "Feature setup - Noise gen.: auto." The purpose of this setup function
is to turn on or turn off the internal noise generator, (used to balance the output levels of the speakers) and to set up
the generator to automatically or manually cycle through the speakers. You can view the three possible settings by
pressing the ">" key on the remote. The possibilities are "auto," "man"(ual) and "off."
If you wish to have the generator cycle through the installed speakers you can select "auto". When setting up the
balance of the installed speakers a speaker will play "white noise" for 2 seconds, then cycle to the next speakers.
When you increase or decrease the level of a playing speaker the generator will continue to play noise through the
speaker until two seconds after you have stopped adjusting it.
When you select "man" the noise generator will play "white noise" through a speaker until you select another by
pressing the ">" or "<" key on the remote.
If you select "off", the noise generator will be turned off, and speaker level balance would be set utilizing an outside
sound source. When balancing the system with an outside sound source you will be required to select the next
speaker by pressing either the ">" or "<" key on the remote.
If you do not wish to select "auto," press the "/\" key on the remote to cycle to "off" or "man." To select a choice be sure
it is displayed in the window, then press the ">" key. (This will enter the option displayed as the preferred mode, and
also move to the next option selection under Feature setup ("Lang.: English")). You may also press the "MENU" key on
the remote. Pressing "MENU" a total of four times will return the SSP-25 to full operational mode.
5.6.2

LANGUAGE

You can select the language you wish the SSP-25 to communicate with you in. The options are English, Spanish and
French.
Press "MENU", then press the ">" key twice to display "Main menu – System setup." Select this option by pressing
"ENTER", then press the ">" key four times to navigate to "System setup – Feature setup."
49