Section 5: Initial System Configuration; Introduction; What You'll Need - Classe Audio SSP-25 Owner's Manual

Section 5: Initial System Configuration

We'll make many references to a "menu" In this Section of the manual. Be aware
that the SSP-25 provides no onscreen setup, but instead provides all information
for setup on its own faceplate screen. The information provided is simple and
straightforward.
The Main (Configuration) MENU System is a complete series of help screens
that lead you through the relatively few steps needed to fully customize the
operation of the SSP-25.
5.1

Introduction

Configuration consists of two basic steps:
1) Telling the SSP-25 what it needs to know about other system components
2) Telling the SSP-25 what it needs to know about your room and loudspeakers.
Of course, there are several elements in each step but remembering these two functional differences will
help you keep your bearings as you follow these suggestions.
5.1.1

What You'll Need

The Configuration MENU System will guide you through all available choices. You'll also need the SSP-25's
hand held remote control.
5.1.2 The MENU Tree
The MENU Tree diagram on the following page will guide you as you move through the various menu screens.
It shows all the choices available and how to reach particular screens efficiently. As you begin to configure the
SSP-25, you'll find that you'll need this diagram less and less. The menu displays themselves provide almost
all the information you'll need to select and lock into memory the various adjustments.
30