Factory Reset; Software Version - Classe Audio SSP-25 Owner's Manual

Press "ENTER" to select. Press the ">" key on the remote twice, and "Feature setup - Lang.: English" will appear in the
display window. Press "ENTER" on the remote to select. There are three choices, which be reached by pressing the
"/\" key on the remote. If you do not wish to select "English," press the "/\" key on the remote to cycle to "Español" and
"Français." To select a choice be sure it is displayed in the window, then press the ">" key. (This will enter the option
displayed as the preferred mode, and also move to the next option selection under Feature setup ("Lang.: English")).
You may also press the "MENU" key on the remote. If you have selected a language other than "English" the selected
language will immediately begin to be used. Pressing "MENU" a total of four times will return the SSP-25 to full
operational mode.
5.6.3

FACTORY RESET

You may decide to completely erase all of your setups and start over from the beginning. You can do this quite easily,
but you should realize that all options will be set to factory default, as per the menu tree on page 30. There is no way to
reverse a reset.
Press "MENU", then press the ">" key twice to display "Main menu – System setup." Select this option by pressing
"ENTER", then press the ">" key four times to navigate to "System setup – Feature setup."
Press "ENTER" to select. Press the ">" key on the remote three times, and "Feature setup - Factory reset" will appear
in the display window. Press "ENTER" on the remote to select this option. As a protection, we have put another step:
you must press "ENTER" again to actually reset the processor, and select all of the factory defaults. (If you do not
wish to reset to Factory Default settings press the "MENU" key).
After you have reset to factory defaults you will need to set up all the operational parameters in order to properly use
the processor.
Press the "MENU" key to exit "Factory reset." Pressing "MENU" a total of four times will return the SSP-25 to full
operational mode.
5.6.4

SOFTWARE VERSION

If you ever require service on your SSP-25, Classé Customer Service may want to know which version of the operating
software is installed on you unit. Follow the guide below to navigate to the Software version query window.
Press "MENU", then press the ">" key twice to display "Main menu – System setup." Select this option by pressing
"ENTER", then press the ">" key four times to navigate to "System setup – Feature setup."
Press "ENTER" to select. Press the ">" key on the remote four times, and "Feature setup - Software version" will
appear in the display window. Press "ENTER" on the remote to select this option. "Software version - ##" will appear
in the display window, with ## replaced by a two number readout. (Software versions may only be changed by
replacing an EPROM in the unit). We very highly recommend an authorized Classé dealer make any change.
Press "MENU" to leave this option. Pressing "MENU" a total of four times will return the SSP-25 to full operational
mode.
50