Clearing Jammed Nails - Grizzly H6144 Instruction Manual

Clearing Jammed
Nails
The most frequent situation with any type
of nailer is a nail jam. A jammed nail must
be cleared before using the nailer again.
To clear a jammed nail from the dis-
charge area on the Model H6144:
1. DISCONNECT NAILER FROM THE
AIR SUPPLY!
Always disconnect air from nailer
whenever clearing a jammed nail!
2. Push the finger tab (Figure 6) inside
the magazine pusher, pull the pusher
back slightly to clear it of the nail stick.
While pressing the finger tab, slide the
pusher forward over the nails until it
rests near the nose.
3.
Continue pressing the finger tab, and
push the nails up the magazine until
they are released from the pusher.
H6144 34° Angle Finish Nailer–2½"
4. Depress the backstop (Figure 6)
inside the magazine and slide the nail
stick out of the magazine.
Figure 6. Finger tab and backstop.
5. Flip up the quick release latch located
on top of the nailer nose assembly as
shown in Figure 7.
Figure 7. Releasing quick release latch.
6. Remove the driver guide cover (Figure
8).
Figure 8. Removing driver guide cover.
Backstop
Finger Tab
-11
-