Clearing Jammed Nails - Grizzly H5570 Instruction Manual

Clearing Jammed Nails

To clear a jammed nail from the dis-
charge area on the Model H5570:
1. Disconnect the nailer from the air
supply!
Pull the spring loaded pusher all the
2.
way back and remove the nail stick.
Flip up the quick release latch located
3.
on top of the nailer nose assembly as
shown in Figure 6.
Remove the driver guide cover as
4.
shown in Figure 7.
5. The jammed nail should now be visi-
ble; remove it from the discharge area
with needle nose pliers.
6. Replace the driver guide cover and
snap the quick release latch back into
operating position.
Figure 6. Releasing guide cover latch.
Figure 7. Removing driver guide cover.
-8
-
Always disconnect air from nailer
whenever clearing a jammed nail!
Cleaning Nailer
Use a good solvent to clean the nose
assembly of the nailer. Always be sure that
the nailer is dry before using it again.
Do not allow dust, chips, sand, etc. into the
air connectors or into the body of the nail-
er; this may result in leaks and damage to
the nailer and the air couplings.
Never use gasoline or other flamma-
ble liquids to clean this tool. Vapors
in the tool may ignite, causing the
tool to explode. Ignoring this warning
may lead to serious personal injury or
even death!
H5570 18 Gauge Finish Angle Nailer