Direct Station Selection (Dss) - Toshiba StrataCT User Manual

Features
2. Dial an Exchange Line or
Exchange Line access
code when you hear dial
tone
...or dial an Exchange
Line or Exchange Line
access code and then a
DISA security code.
3. Dial a telephone number.

Direct Station Selection (DSS)

This optional feature enables you to use a
of the button shows the status (idle/busy) of the station and/or the station's [PDN].
For example, a station DSS LED shows busy (light steady red) when the station is:
Busy on a call on any button or is in the DND mode.
Idle, but all appearances of the [PDN] are in use by other stations.
To connect directly to another station [PDN]
1. Press
Exchange Line or another station.
2. Announce the call
...or transfer the call by hanging up
...or transfer the call by pressing
RLS/ANS RLS/ANS RLS/ANS RLS/ANS
Strata CT Electronic Telephone User Guide November 2001
DSS DSS DSS DSS
, while connected to an
.
If you do not hear dial tone, you must also dial a DISA
security code. See Table 7
You hear dial tone.
See the System Administrator for the DISA security
Note
code number. If the correct code is not entered, the
call disconnects.
If set in system programming, both parties hear a warning
tone approximately 4, 10, or 20 minutes after the call was
0 0 0 0
made. Press to reset the timer each time the tone sounds (for
an additional 4, 10, or 20 minutes). If you do not press
call disconnects approximately one minute after the tone.
DSS DSS
DSS DSS
button to connect directly to another station. The LED
The original party is put on hold. You can call a station
even if the DSS LED shows busy (steady red).
Note You can transfer the call to an idle or busy
station.
Direct Station Selection (DSS)
on Page 62.
0 0 0 0
, the
41