Direct Station Selection (Dss) - Toshiba Strata DK User Manual

2. Dial a CO Line or CO
Line access code
when you hear dial
tone
...or dial a CO Line
or CO Line access
code and then a
DISA security code.
3. Dial a telephone
number.

Direct Station Selection (DSS)

This optional feature enables you to use a
station. The LED of the button shows the status (idle/busy) of the station and/or the
station's [PDN].
For example, a station DSS LED shows busy (light steady red) when the station is:
Busy on a call on any button or is in the DND mode.
Idle, but all appearances of the [PDN] are in use by other stations.
To connect directly to another station [PDN]
'66
1. Press
connected to a CO
Line or another
station.
Strata DK Electronic Telephone 5/99
If you do not hear dial tone, you must also dial a DISA
security code. See
You hear dial tone.
Note
If set in system programming, both parties hear a
warning tone approximately 4, 10, or 20 minutes after
the call was made. Press
the tone sounds (for an additional 4, 10, or 20
minutes). If you do not press
approximately one minute after the tone.
, while The original party is put on hold. You can call a station
even if the DSS LED shows busy (steady red).
Table 7 on Page
See the System Administrator for the DISA
security code number. If the correct code is not
entered, the call disconnects.

'66
button to connect directly to another
The Grand Tour
Direct Station Selection (DSS)
64.
to reset the timer each time

, the call disconnects
41