Message Waiting - Toshiba StrataCT User Manual

Message Waiting

START START START START
5. Press
Message Waiting
All telephones have a standard MW/FL LED for receiving/retrieving messages left by callers that
called a [PDN] that was busy or did not answer. Telephones that own [PhDNs] can also have up to
four additional (flexible) message waiting [PhDN/MW] buttons and LEDs. The fourth message
waiting button is reserved for the Message Centre.
The MW/FL LED at the called station flashes to notify you that someone called while you were busy
on another call or away from your office. You can call the other party back by pressing the
button. Voice mail devices, as well as people, can leave message waiting indications.
If you have an LCD telephone, up to four message waiting displays may be
stored on the LCD per each [DN]. The LCD can show up to three stations that
have left messages for your [PDN] and three for each of your [PhDNs]. The
fourth message waiting button is reserved for the Message Centre.
To answer a Message Waiting on your [PDN]
1. Press
the handset.
The LCD can show up to
three stations that have
left messages for the
[PDN] and three for each
of your [PhDNs].
2. Press
them.
48
. The dialled digits will not be sent until you press this button or until
the timer expires.
MW/FL MW/FL MW/FL MW/FL
and lift Your phone rings the station or voice mail device that set the
indication. The LED continues to flash red.
If you reach a station that is busy or does not answer, go
on-hook and press
next message sender.
In the example (shown at right), the
display indicates that station DN [
received a message signal from DN
[
SCRL SCRL SCRL SCRL
to display
MW/FL MW/FL
MW/FL MW/FL
]. The "+" indicates additional messages.
201
Strata CT Electronic Telephone User Guide November 2001
CALL 203-201+
again. The system rotates to the
]
203
CALL 203-201+
Features
MW/FL MW/FL MW/FL MW/FL
NO. 204
NO. 204