Entering An Address Without Knowing The Dictrict/Suburb - Kogan EziNav G3 User Manual

4. Pick the street from the list.
5. Enter the house number:
1. Tap
2. Enter the house number on the keyboard.
3. Tap
6. A list appears with the matching addresses. Tap the desired one.
7. The map appears with the selected point in the middle. Tap
(Simple mode) or
route is then automatically calculated, and you can start navigating.

3.1.2.4 Entering an address without knowing the dictrict/suburb

Long roads can run across several districts or suburbs. You may not know if a particular
house number is in which of them. In this case, follow the instructions below:
The procedure is explained starting from the Navigation menu.
1. Tap the following buttons:
mode).
2. By default, Nav N Go iGO 8 proposes the country/state and settlement where you are.
If needed, tap the button with the name of the country/state, and select a different one
from the list.
3. If needed, change the settlement:
•
To select the settlement from the list of recently used ones, tap the
button.
•
To enter a new settlement:
1. Tap the button with the name of the settlement, or if you have changed
the country/state, tap
2. Start entering the settlement name on the keyboard.
3. Get to the list of search results:
•
•
4. Pick the settlement from the list.
4. Enter the street name:
1. Tap
36
.
to finish entering the address.
(Advanced mode) from the Cursor menu. The
After entering a couple of characters, the names that match the
string appear in a list.
Tap
appears automatically.
.
(Simple mode), or
.
to open the list of results before it
, (Advanced