Fuses; Battery; Fuse Replacement - KYMCO Super 8 50 Owner's Manual

MAINTENANCE
Battery removal & installation
The battery 1 is in the battery box under the floor board mat 2.
NOTE: Always keep ignition switch OFF when servicing
the battery.
1 1 1 1 1
1. When removing the battery for charging or replacement, dis-
connect the negative (-) terminal lead from the battery first,
then disconnect the positive (+) terminal lead.
2. When installing the battery, connect the positive terminal
lead (+) first, then the negative terminal lead (-).

Fuses

When frequent fuse failures occur, it usually indicates a short
circuit or an overload in the electrical system.
NOTE: See your KYMCO dealer for electrical system
diagnosis and repair.

Fuse replacement

FUSE SIZES: 7A, 10A, 10A
1. Open the fuse holder 3.
Pull the fuse holder clips 4
out of the holder.
2. Slide the fuse 5 out of
the holder clips.
3. Install a new fuse 6 of
the proper specification
into the holder clips.
2 2 2 2 2
4. Press the fuse and the
holder clips 4 back into
the holder.
5. Close the fuse holder 3
and set it back in place.
Never use a fuse with a different rating from that speci-
fied. Serious damage to the electrical system or a fire
hazard may result, causing a dangerous loss of lights
or engine power.
3 3 3 3 3
4 4 4 4 4
6 6 6 6 6
3 3 3 3 3
4 4 4 4 4
6 6 6 6 6
37