Xantrex PRO XM 1000 Owner's Manual page 43

Installation
5. Using a jigsaw or other suitable tool, make a hole in the wall or
6. Plug the male end of the RJ11 extension cord into the XM Series
7. Route the RJ11 extension cord (through the wall or behind the bulkhead,
8. Plug the jack from the remote panel cord into the female jack on the
9. Secure the remote panel to the wall with the two screws you removed
3–24
bulkhead into which to insert the remote panel.
The hole should measure 3 1/4 inches (83 mm) across by 1 1/3 inches
(33 mm) high, with at least 1 1/2 inches (40 mm) of depth to allow space
for the remote panel cord to bend.
Inverter.
if necessary) to emerge from the hole you prepared.
extension cord.
earlier, or with similarly sized screws appropriate for your mounting
surface.
975-0263-01-01