Installing Mill Table - Grizzly G0516 Instruction Manual

Installing Mill Table

The Model G0516 includes a milling table as an
accessory. When the Model G0516 is shipped
from the factory, the compound slide is mounted
on the cross slide and must be removed before
the milling table can be installed. Once installed,
the milling table moves back and forth with the
cross slide.
To install the mill table:
1.
Use a 12mm wrench to remove the two bolts
that secure the compound slide to the cross
slide. See Figure 59.
Figure 59. Removing compound slide bolts.
2.
Remove the compound slide from the cross
slide.
3.
Place the milling table on the cross slide so
the mounting bolts line up with the threaded
holes.
-36-
4.
Secure the milling table to the cross slide,
using a 6mm allen wrench with the table
mounting cap screws. Figure 60 shows the
milling table installed on the cross slide.
Figure 60. Mill table installed on cross slide.
G0516 Lathe/Mill