CYP PU-8H8HBTE Operation Manual page 15

8 x 8 hdmi hdbaset matrix (5-play including lan serving)

Hide thumbs Also See for PU-8H8HBTE:

Table of Contents

Once in the command line interface (CLI) type "telnet", a space, then the

IP address of the unit you wish to control, a space and "23", then hit enter.

Note: The IP address of the Matrix can be displayed on the device's LCM

monitor by pressing the Menu button twice.

This will bring us into the device which we wish to control. Type "HELP" to

list the available commands.

Type "IPCONFIG" To show all IP configurations. To reset the IP, type "RSTIP"

and to use a set static IP, type "SETIP" (For a full list of commands, see

Section 6.7).

Note: Any commands will not be executed unless followed by a carriage

return. Commands are not case-sensitive. If the IP is changed then the IP

Address required for Telnet access will also change accordingly.

Table of Contents

Need help?

Do you have a question about the PU-8H8HBTE and is the answer not in the manual?